Purchase Record And Service Contacts; Rs232 In Settings; Determine The Ip Address Using The Serial Port - Christie ACT User Manual

1.2

Purchase Record and Service Contacts

Whether this product is still under warranty or the warranty has expired, Christie's highly trained and extensive
factory and dealer service network is always available to quickly diagnose and correct malfunctions.
Should you encounter a problem with this product, please contact your dealer listed on the back cover of this
manual. If you have purchased the product, fill out the form below and keep with your records.
Table 1.1 Purchase Record
Dealer/Christie Sales Contact:
Dealer/Christie Sales Contact Phone Number:
Christie ACT Serial Number*:
Purchase Date:
Installation Date:
* The serial number can be found on the license label located on the side panel of the product.

1.2.1 RS232 IN Settings

Table 1.2 Serial Port Default Settings
Baud Rate (Bits Per Second)
Data Bits
Parity
Stop Bits
Protocol
Mode
Flow Control

Determine the IP Address Using the Serial Port

You can determine Christie ACT's current IP address by connecting to Christie ACT using the RS232 IN port
and rebooting Christie ACT (reboot by unplugging the power cord and plugging it back in). As Christie ACT
boots up it will display the current Ethernet settings over the serial connection.
The Ethernet settings can also be queried by using these serial commands:
(net+eth0?) - query the current IP Address
(net+sub0?) - query the current Subnet Mask
(net+gate?) - query the current Gateway
Christie ACT User Manual
020-100129-05 Rev. 1 (02-2010)
RS-232 IN RS-232 OUT
115,200 115,200
8 8
None None
1 1
Script Script
Protocol Protocol
8N1 8N1
None None
Section 1: Introduction
RS-422 RS-232 OUT
(Audio)
19,200 9,600
8 8
None None
1 1
Script Script
Protocol Protocol
8N1 8N1
None None
1-3