Page 1
User Guide 020-102717-02 Christie E600 LED Display Controller...
Page 2
The warranty does not apply to any product where the serial number has been removed or obliterated. The warranty also does not apply to any product sold by a reseller to an end user outside of the country where the reseller is located unless (i) Christie has an office in the country where the end user is located or (ii) the required international warranty fee has been paid.
Learn about the interface and physical ports on the E600 controller. The E600 controller behaves as two independent controllers, displaying 3840 x 2160 pixels at 30 Hz with each virtual controller. The images of both DVI1 and DVI2 input sources can be displayed on the tiles simultaneously, but the inputs must be configured independently.
12 bit RGB444 YCbCr444 YCbCr422 YCbCr420 FE600 controller extender interface and ports Learn about the interface and physical ports on the E600 controller. Front Status display Christie E600 LED Display Controller User Guide 020-102717-02 Rev. 1 (10-2018) Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
Page 8
USB, RJ45 (with SNMP support), and USB cascading USB In OPT Output (Qty. 4) Fiber optic ports for connecting to the E600 controller • OPT1 is used for transferring the data of port 1-8 • OPT2 is used for transferring the data of port 9-16 •...
Indicates the ratio between the area covered by pixels and the area not covered by pixels. Product documentation For installation, setup, and user information, see the product documentation available on the Christie website. Read all instructions before using or servicing this product.
Configuring the array Perform these tasks when configuring the array. To configure the array, the computer running the E600 controller software must be connected to the controller with a USB A to B cable. Installing/Accessing the E600 controller software The E600 controller software controls the configuration of the array.
Testing the communication between the controller and tiles Verify that the array is connected to and recognized by the E600 controller. 1. Connect a USB cable between the controller and the computer running the controller software. 2. Launch the controller software and log in as the administrator.
7. Click Close. Reviewing the tile configuration Review the tile configuration reported in the E600 controller software. 1. Connect a USB cable between the controller and the computer running the controller software. 2. Launch the controller software and log in as the administrator.
Configuring the array Configuring HDR The E600 controller supports High Dynamic Range (HDR), presenting more vivid and clearer images. 1. On the front of the controller, press the menu dial. 2. Select Advanced Settings > HDR. If an HDR source cannot be detected on the HDMI input, the option is grayed out and disabled.
• CDS-SMI.mib • CDS-E500.mib 3. Import the Christie MIB files into the browser. Load the CDS-SMI.MIB file first, and then load the CDS-E500.MIB file. 4. Configure the SNMP alarms, and identify where alarms and trap messages are sent. MIB traps Understand what the MIB files monitor.
Page 23
Corporate offi ces Worldwide offi ces Christie Digital Systems USA, Inc. Australia Germany Republic of South Africa United Kingdom Cypress ph: +61 (0) 7 3624 4888 ph: +49 2161 664540 ph: +27 (0)11 510 0094 ph: +44 (0) 118 977 8000...