Salus AX10RF System Manual page 30

Section 4
Step 2. Open the SALUS Smart Home mobile application and select the drop-down menu from
the upper right side of the screen:
Equipment Add New Equipment

Step 3. Click the "Scan for equipment" button . The SG888ZB Gateway will flash red as it searches
for devices .
The red LED backlight on the Auto/
Manual Switch will turn steady on .
Once the AWRT10RF Thermostat
joins a network, the
stop flashing and the network
channel will be displayed briefly .
The home screen will show
PAIRING- - - with a 10-Minute
countdown timer as the
AWRT10RF Thermostat looks for
an RX1 device .
AWRT10RF Pairing with
Internet Connection (SG888ZB Gateway)
Scan for Equipment

After pairing is complete,
icon will a confirmation screen
is displayed on the
AWRT10RF Thermostat
for 3 seconds, then the
device will enter the
parameter setup mode .
Auto Manual
On Off
The thermostat display will
show "PAIR: RCV1" with P
01 indicating it is in the
parameter setup mode .
"Cn" (Connected) indicates
that the AX10RF Receiver is
paired and connected .
4 .10