Salus AX10RF System Manual page 46

Section 6
Once the AWRT10RF
Thermostat has joined the
network, the screen will
show PAIRING- - - with a 5
minute countdown timer .
Step 3. Press the
key to exit setup and start normal operation . The AWRT10RF Thermostat display will
show the current room temperature, target temperature, relative humidity along with indicators for the
temperature mode and network status . The red LED backlight on the Auto/Manual switch will not be
flashing .
Step 4. Press the pairing button on the AC10RF Coordinator to exit pairing mode and
begin normal operation .
The AWRT Wireless Radiant Thermostat defaults to Non-programmable mode and doesn't show
time or date. For details on changing to programmable mode, see Section 8, Parameter Setup.
AWRT10RF Pairing without Internet
Connection (AC10RF Coordinator)
After pairing is complete,
a confirmation screen
is displayed for 3
seconds, the AWRT10RF
Thermostat enters the
parameters set up mode .
The display will show
PAIR: RCV1 with P
01 indicating it is in
the parameter set up
mode . Cn (Connected)
indicates that the
AX10RF Receiver is
paired and connected .
Auto Manual
On Off
6 .8