Resetting The Akl01/04/06Prf Zone Pump Or Akl08Rf Zone Valve Wiring Center - Salus AX10RF System Manual

Section 7
Resetting the AKL01/04/06PRF Zone Pump
or AKL08RF Zone Valve Wiring Center
To reset the AKL Wiring Centers, locate
the Pair button on the top of the cabinet
near the cover screw on the right side.
1 . Press and hold the Pair button for about 20
seconds until the G1/G2 lights start flashing .
After releasing the button, the network status light begins flashing
2 . To complete the reset, cycle the power to the Wiring Center off for 10 seconds .
The AKL Wiring Center WILL NOT OPERATE correctly until the power is cycled off and on.
To reset the AKL Wiring Centers, delete them from the SALUS Smart Home mobile application as follows:
1 . Select the menu from the
upper right of the home screen .
4 . Choose the appropriate
Wiring Center from the list .
7 . Once the AKL Wiring Center is removed, be sure to cycle off the power for more than 10 seconds
to fully reset the unit .
Resetting Factory Defaults
without Internet Connection
with Internet Connection
2 . Choose "Equipment"
5 . Scroll to the bottom of
the screen .
3 . Then choose, "All equipment"
6 . Select "Remove Wiring Center" .
7 .4