Pairing With Ax10Rf Receiver For Boiler Switching (Rx1) - Salus AX10RF System Manual

Section 4

Pairing with AX10RF Receiver for Boiler Switching (RX1)

• This pairing procedure is only used when direct control of an AX10RF Receiver by the
AWRT10RF Thermostat is desired.
• Each system will support only one AX10RF configured as RX1 and one configured as RX2.
This configuration is typical in boiler systems in which there is only one thermostat in the system such
as a single steam heating loop or single forced circulation, hot water loop. For systems with multiple
zones, a zone relay controller such as the SALUS AKL Series is recommended.
Before starting the pairing process, be sure that the AX10RF Receiver is installed as shown in the
installation instructions included with the device .
• The switch on the inside cover must be configured to RX1
• The LED backlight on the Auto/Manual switch of the AX10RF Receiver should be flashing red
• The Auto/Manual switch of the AX10RF Receiver should be in the AUTO position
• The SG888ZB Gateway must be powered with solid blue LED indication that it is connected to
the internet
• The AWRT10RF Thermostat should be powered up and flashing PAIR? RLAY_CTL
Step 1. On the AWRT10RF Thermostat,
press
until PAIR? RCV1 is displayed .
Press SELECT .
AWRT10RF Pairing with
Internet Connection (SG888ZB Gateway)
JOINING- - - will be displayed with a 10
minute countdown timer and a flashing
network status indicator .
4 .9