Ax10Rf Receiver Installation - Salus AX10RF System Manual

Section 3

AX10RF Receiver Installation

The AX10RF Receiver can be configured as a system remote boiler switch (RX1) or a single channel
output to a thermal actuator or zone valve .
The AX10RF Receiver must be installed by a qualified contractor. Installation and repairs are to be
performed according to all national and local codes required by the authority having jurisdiction. In the
absence of local requirements, follow ANSI/NFPA 70, National Electrical Code. Failure to follow these
requirements may lead to severe personal injury, death or major property damage. DO NOT SERVICE
this equipment without disconnecting the AC electrical power.
1 . Carefully read these instructions and all
instructions supplied with the unit before
starting the installation .
2 . Inspect the control for damage and be sure all
required parts are included before beginning .
3 . Remove the cover by loosening the 2 screws on
the bottom of the unit and rotating the bottom
upward until the top clips disengage .
4 . Attach the AX10RF Receiver to the wall in the
desired suitable location .
BOILER
DO NOT INSTALL this control in an area where water
leaks or spray are possible. Failure to comply may
result in serious injury, death or major property
CH DEMAND
damage due to electrocution or fire.
5 . Slide the configuration switch on the back of
AX10RF WIRING SCHEMATIC
RX1 CONFIGURATION FOR BOILER SWITCH
the cover to the desired position:
• RX1 for system remote boiler switch
• RX2 for valve actuator output
6 . Wire the receiver using the appropriate schematic diagram .
7 . Re-attach the cover by engaging the cover clips with the
top of the unit and rotating downward until it closes .
NOTES:
1) .
2) .
3) .
8 . Fasten the screws at the bottom of the unit .
REVISION
BY: _ _ DATE:
0 __/__/__
___ _
Device Installation
24 VAC SUPPLY
RX1
H H N N
RX2
AX10RF
NO
RECEIVER
COM
KEY:
THIS DOCUMENT CONTAINS
INFORMATION PROPRIETARY
TO AZ ENGINEERING.
DISCLOSURE OF ANY
INFORMATION CONVEYED OR
IMPLIED BY THIS DOCUMENT
WITHOUT EXPRESS WRITTEN
CONSENT BY AZ
ENGINEERING IS FORBIDDEN.
RX1 CONFIGURATION FOR BOILER SWITCH
NOTES:
1) .
2) .
3) .
REVISION
BY:
_ _
0
___ _
RX2 CONFIGURATION FOR ZONE VALVE
WATER
Z
ZONE VALVE
ELECTRICAL
CONTROL BOUNDARY
APPROVED BY DATE
BOILER
RX1
H
RX2
CH DEMAND
NO
COM
AX10RF WIRING SCHEMATIC
BOILER
RX1
H
RX2
CH DEMAND
NO
COM
DATE:
__/__/__
AX10RF WIRING SCHEMATIC
AZ ENGINEERING LLC
AX10RF WIRING SCHEMATIC
RX1 & RX2 CONFIGURATIONS
SCALE: DRAWING NO:
NONE
SCI-180823-01
CN: DRAWN BY: DATE:
--
SCEARCE 2018-08-23
24 VAC SUPPLY
H N N
AX10RF
RECEIVER
24 VAC SUPPLY
H N N
AX10RF
RECEIVER
KEY:
WATER
Z
ELECTRICAL
CONTROL BOUNDARY
ZONE
APPR
Z
THIS DOCUMENT CONTAINS
VALVE
INFORMATION PROPRIETARY
TO AZ ENGINEERING.
DISCLOSURE OF ANY
INFORMATION CONVEYED OR
IMPLIED BY THIS DOCUMENT
WITHOUT EXPRESS WRITTEN
CONSENT BY AZ
ENGINEERING IS FORBIDDEN.
3 .11
REVISION:
00
SHEET 1 OF 1