Table of Contents
Advertisement
Section 4
Step 4. On the SALUS Smart Home
application, check the boxes for both the
AWRT10RF Thermostat and the AX10RF
Receiver . Press "Connect equipment" .
AX10RF(RX2)
AWRT10RF-1
Step 6. After naming the devices,
the application will show that set
up is complete . Press Finish to
finalize the application setup .
AWRT10RF Pairing with
Internet Connection (SG888ZB Gateway)
AX10RF(RX2)
AWRT10RF-1
Step 5. Enter a descriptive name for each device .
Press "Next" to continue . Since the receiver is
already paired, when the AWRT10RF Thermostat
is renamed it will immediately go to the home
screen, ending parameter setup .
If you do not rename the AWRT10RF Thermostat in the
SALUS Smart Home application, the device may stay in
parameter setup mode. Press the
key to exit setup.
4 .14
Hide quick links:
Advertisement
Table of Contents
