Siemens SIPROCESS GA700 Compact Operating Instructions page 176

Commissioning
6.4 Commissioning the SIPROCESS GA700
3. Wait for transition to warming-up phase:
When the splash screen disappears, the device is in the warming-up phase. The current
temperature status is displayed as a bar graph in the warming-up window.
4. Call the measured-value display during the warming-up phase
– Close the warming-up window by pressing <ENTER>.
Setting up
Note
Operator control options
When commissioning for the first time, two methods can be used. You can commission the
device for the first time with the procedure described below or you can use a simplified
procedure.
Information on simplified procedure → Table A-1 References 1 - Operating Manuals LUI
(Page 91). Make the necessary settings in the appropriate submenus.
If you do not use the quick start procedure, commission the device with the steps described
below:
1. Call the main menu:
– Switch the measured-value display to selection mode.
– Press <Enter> again to open the main menu.
2. Identify device: [3.09] Maintenance & Diagnostics > Identification
3. Define PIN for the user levels: [5.1] Security > Access management
In the factory settings, the PIN 1111 is the default for the "Standard" user level and PIN
2222 for the "Expert" user level.
4. Disable automatic log-off temporarily:
The factory setting is a log-off time of 5 min. When this time elapses, changes that were
not stored retentively are lost. We recommend that you temporarily deactivate the automatic
log-off during commissioning.
70
The display shows the measured-value display in read mode.
For the duration of the warming-up phase, the device is in "Function check" mode. The
following symbol is displayed in the status bar:
To do so, press <ENTER>.
Devices in explosion-proof design
Compact Operating Instructions, 05/2015, A5E35134047-02