Connection Of The Signal Cables - Siemens SIPROCESS GA700 Compact Operating Instructions

1. Connect the wires of the connecting cable to the appliance plug
power supply and PE conductor connections are correct!
The following information applies to the power connector that can be ordered as an option:
Tighten the screws in the appliance plug with a torque of:
– 0.5 Nm at the terminals
– 0.3 Nm at the cable terminals (strain relief) and the connector housing
2. Connect the appliance plug
3. Attach the securing bracket
Tighten the screw on the rear panel of the enclosure with a torque of 2.5 Nm.
4.2.2.2

Connection of the signal cables

Note
Securing the signal cables
To secure the signal cables:
1. Fasten the Sub-D connectors.
2. Secure the Ethernet cable with a cable tie to the supplied strain relief.
Devices in explosion-proof design
Compact Operating Instructions, 05/2015, A5E35134047-02
④
to the power supply unit
⑤
.
Connecting
4.2 Electrical connections
④
. Make sure that the
①
.
43