How To Fit Tower Unit; Tools Required - Howdens TOWER UNIT 3 DRAWERS Assembly Instructions Manual

HOW TO FIT
TOWER UNIT
Assembly Instructions Assembly Instructions

TOOLS REQUIRED:

TOOLS REQUIRED:
Assembly Instructions
TOOLS REQUIRED:
Ii'\ Ii'\
Please check your opening for any Please check your opening for any
\.:.I \.:.I
hidden electrical wires and water hidden electrical wires and water
pipes before/ screwing. pipes before/ screwing.
II II
Screws not supplied. Screws not supplied.
/7})\ /7})\
'<SV '<SV
Use suitable screws Use suitable screws
and plugs. and plugs.
[!I [!I .. ..
Please check your opening for any
hidden electrical wires and water
pipes before / screwing.
Screws not supplied. Use
suitable screws and plugs.
Page 1 of 2
Place your tower unit into position (This can be left, centre
or right aligned).
Once in position, measure side A. (Tip: Measure approximately
V1
where the hanger will be placed).
Cutting around skirting boards (optional). Mark using a
compass then cut using a coping saw.
-- - ----- -- - -----
A
Measure and cut.
Width (A) - 6mm
e· e·
i.e 1200 - 6mm = 1194mm 1200 - 6mm = 1194mm 1200 - 6mm = 1194mm
1 1
UNB_TUDRAWER_INSTR_01.19