Maintenance And Cleaning; Daily Control - Kalor Cloe 17B User Manual

Maintenance and cleaning

All cleaning of all parts must be carried out with the Hydro Insert completely cold
and unplugged to avoid burns and thermal shock. The Hydro Insert does not need
much maintenance if used with certified quality pellet. The need for maintenance
varies depending on the conditions of use (switching on and off repeatedly) and
depending on the performance required.
of the Hydro Insert to check its condition.
Parts
Brazier
Cleaning the ash collection
compartment with suction device
Cleaning ash tray
Cleaning the interior heat exchanger /
smoke fan compartment
Cleaning complete exchanger
Clean "T" to exhaust
Flue
Door gasket ash
Internal parts
Flue pipe
Circulation pump
Hydraulic components
Electromechanical components
◊ by the user / • by the authorised qualified technical assistance
BY THE USER

Daily control

The Hydro Insert requires a simple and thorough cleaning
in order to ensure a more efficient performance and
smooth operation. While cleaning the inside of the Hydro
Insert, to prevent the escape of ashes, you can start the
fan flue exhaust. Clean the grate from the ash and any
incrustation which could obstruct the passage of air. In the
case of depletion of pellets in the tank may accumulate
unburned pellets in the burn pot.
Always empty the residuals from the grate before each
start. Remember that only a brazier located and clean
properly can ensure ignition and optimal operation of
your Hydro Insert. When positioning the crucible, carefully
check that the ends of the pads completely adhere to
their home and that the hole with pipe dedicated to the
passage of the resistance. There should be no residual
combustion in the contact zone between the edges of the
crucible and the support surface on the door crucible.
Every 2-3
Everyday
days
◊
◊
◊
It is recommended periodic monitoring
Every Every 15 Every 30
week days days
Every 60- Every 1
90 days year
•
•
•
•
•
•
•
•
•
•
129