Flame-Shell Cleaning; Cleaning Of Stainless Steel And Satin-Finish Surfaces; Lower Ash Drawer Cleaning; Shutting Down - Kalor Cloe 17B User Manual

Controllo ogni 2-3 giorni
Cleaning the ash collection compartment
Clean and empty the ash tray being careful with hot ash.
The ash must be completely cold for a vacuum cleaner to
be used to remove it. Only if the ash is completely cold,
you can also use a canister vacuum cleaner suitable for
picking up particles of a certain size.
Cleaning ash and combustion chamber including the
spark plug lead.

Flame-shell cleaning

Cleaning of stainless steel and satin-finish surfaces

Normally these surfaces do not need to be treated, but
if they do, avoid cleaning them with abrasive materials.
For surfaces in stainless and satin brushed steel we
recommend cleaning with a paper towel or a clean dry
cloth moistened with a detergent based on non-ionic
surfactants (<5%) A spray glass cleaner may be used.
Avoid contact with skin cleanser
and eyes. In case this happens,
sprinkle with plenty of water
and contact the nearest medial center.
Cleaning of painted pats
Do not clean the painted parts with wet rags when the
unit is in operation or hot to prevent thermal shock to the
paint which may cause it to detach. Do not use abrasive or
aggressive products or materials. Clean with damp cotton
or paper towels. The silicon paints used by manufacturer
possess technical characteristics that make them resistent
to very high temperatures. There is however a physical limit
(380° C - 400° C) beyond which the paint begins to fade or
(over 450°) to vitrify; it may then flake and detach from the
steel surface. If this happens, it means that temperatures
have been reached that are far above those at which the
unit should operate properly.
130
Do not use abrasive materials or
harsh. Clean with damp cotton or
paper towels.

Lower ash drawer cleaning

Si raccomanda la pulizia del cassetto cenere dai residui
caduti durante il funzionamento. Remove the grid, take
out the tray, empty and clean the corners with a suction
device.
Shutting the Hydro insert down
In the period when the Thermostove is out of use it
must be disconnected from the electricity mains. For
greater safety, especially if there are children around, we
recommend removing the power cable from the rear of the
Hydro insert.
Before placing the Hydro Insert in storage, you should
remove all pellets from the hopper with a vacuum cleaner
with a long extension. If the fuel is left in the hopper, it
may get damp, stick together, and be difficult to light at
the beginning of the next season. If pressing the main
switch (located on the back of the Hydro Insert) does not
make the control panel display light up, it could mean
that the service fuse needs replacing. On the rear of the
Hydro Insert there is a fuse holding compartment which is
located underneath the supply socket. With a screwdriver
open the cover of the fuse holding compartment, and re
place the fuse if necessary (3,15 AT delayed type). Plug
the unit back in and press the main switch.