Using File Memory; Initializing Media - Omron SYSMAC CS/CJ Series Programming Manual

Using File Memory

5-3 Using File Memory
5-3-1

Initializing Media

Memory Cards
1,2,3...
EM File Memory
1,2,3...
CX-Programmer
CX-Programmer
Initializing Individual EM
File Memory
226
When the Power Supply Switch is pressed, the MCPWR Indicator will flash
once, light during the compare operation, and then go OFF if the compare
is completed normally and the data is the same.
Note Confirm that the Units and Boards are running properly before attempting the
above operations. The write, read, and compare operations will not be per-
formed unless the Units and Boards are running properly.
1. Use a Programming Device, such as a Programming Console, to initialize
Memory Cards.
Or
CX-Programmer
1. Use a Programming Device like a Programming Console and set EM file
memory settings in the PLC Setup to enable EM file memory, and then set
the specified bank number for EM file memory to 0 to C Hex.
Or
Programming
Console
2. Use a FINS command or a Programming Device other than a Program-
ming Console to initialize EM file memory.
Or
Programming
Console
A specified EM bank can be converted from ordinary EM to file memory.
Note The maximum bank number for CJ-series CPU Units is 6.
Programming
Console
Initialize EM file memory.
Section 5-3
Memory Card
Specify the starting
bank number for
EM file memory.