Kessel Aqualift F Installation Manual page 21

Menu Display
The navigation of the menu takes place in the System Info
section of the display as well as three other main menu
sections. Pressing any control unit button will backlight the
display.
OK button: will enter one level deeper into the menu
ESC button: will exit the current level
will navigate inside a menu level
▲:
▼
If a power outage occurs, the pumping station is no lon-
ger operational. The control unit will go into stand-by mode
(battery operation of the control unit only). This will be sig-
nalled by an audible and optical alarm. Pressing the alarm
button will confirm the current situation and turn off the au-
dible alarm. The stand-by mode will run on battery power
for at least 72 hours – after this the control unit will auto-
matically shut itself down. In the case that power is resto-
red to the unit, the control unit will begin running again the
exact program phase it was in. If this is not the case, the
6. Commissioning
Pumpstation
Schwimmer
21
When the control unit is plugged in the
user will be prompted to make the follo-
wing four basic selections:
1) Language desired
2) Current date and time
3) Type of level sensors (float switches /
pressure switched etc)
4) Pump size (kW)
Using the buttons on the display unit, the
desired setting can be selected and then
confirmed by pressing the OK button. As
soon as the four selections are set, the
control unit will automatically load the set-
ting – the control unit is now in operation
and the entire Aqualift F pumping station
is now in normal operation mode.
control unit will automatically re-initialize itself. This can be
done by keeping the Alarm button pressed.
Note:
Certain levels of the control unit display are password pro-
tected – which protects certain settings from unwanted ac-
cess.