Kessel Aqualift F Installation Manual page 11

Installing the chamber seals / gaskets
Each chamber section is connected using a gasket (the size
of this gasket will vary depending on if an 800 or 1000 cham-
ber is being installed and on the specific section being in-
stalled). The recessed area for the gasket (located on the top
of each section as seen in the illustration) should be clean
and free from all debris / sand. Firmly place the gasket into
the recessed area of the chamber. The upper exposed por-
tion of the gasket should now be lubricated with a standard
gasket lubricant.
Access step installation
Access steps (included with KESSEL 1000 chamber) (Avai-
lable as accessory with KESSEL 800 chamber). Access
steps may be installed prior to assembling the individual
chamber sections. Steps are installed as shown in the dia-
gram below.
4. Installation and Assembly
11
Installing chamber sections
Now place the next chamber section on top of the other ma-
king sure that the location for access steps are in line with
the lower portion. The steps should be in a left / right / left /
right pattern to aide in accessing the chamber after installa-
tion is complete. If connected properly the 600mm open ac-
cess to the chamber in the cone section should be directly
above the access steps. Connect the two chambers sections
with the supplied clipping systems as seen in the illustrations.
Installing the vertically adjustable upper sections • Firmly insert cu-
stom gasket into
recessed area of
cone section -
using hammer if
required
• Lubricate interior
exposed portion
of the gasket, in-
sert upper sec-
tion and secure
with clamping
ring
• Final elevation /
slope adjust-
ments can be
made with the 3
adjustment scr-
ews which should
be upside down
(screws heads
should be at bot-
tom – threads on
top)