Table of Contents
Advertisement
System Configuration
Config Menu Options
Type
C
at the console screen
options and the order of system configuration.
Table 17. Config Menu Options and Recommended Order of System Configuration
Use this Option
Terminal Settings
Date and Time
Password
Circuit ID
System Settings
LTU and NTU Interface
Alarms
Set to Factory Dflts
Observe the following when configuring a system:
•
Configure settings in the order specified in
and NTU Interface settings. Changing System Settings can clear values configured in LTU and NTU Interface
settings.
•
When using a UTU as an LTU, change the Local Unit Role for the unit using the Config System Settings
menu. Note that changing the Local Unit Role of a UTU causes the unit to reset and the LEDs to cycle.
•
When the HDSL units are reset or cycle power, the date field is preserved but the time field is not preserved.
Set the time using the Config Date and Time display. When the HDSL units are turned off and left off for a
longer period of time (more than 24 hours, for example), set both the date and time using the Config Date and
Time display since neither value was preserved.
32
(Figure
15)
to display the Config menu
Figure 16. Console Screen Config Menu
To:
Select the best viewing mode for the console screen.
Set the system date and time.
Set or change the system password.
Assign a circuit ID.
Select and configure system-wide operating parameters.
Select and configure LTU/NTU-specific operating parameters.
Enable or disable alarms and to select alarm severity.
Reset all operating parameters to factory settings.
Table
17. The System Settings must be configured before the LTU
August 9, 2002
(Figure
16).
Table 17
lists the Config menu
See page:
33
34
35
36
37
39
42
and
44
UTU-701 and ETU-751 List 1
700-701-100-02
43
Advertisement
Table of Contents
