Download Print this page

ADC ETP-64 Specification Sheet

Adc ethernet termination panel specification sheet

Advertisement

Quick Links

ETP-64 Ethernet Termination Panel
Central Office Connectivity for Carrier Ethernet Services
The Ethernet termination panel was developed to provide a streamlined transition from the
connectorized interface cables of a carrier Ethernet system to main distribution frame (MDF)
paired circuits.
The panel is relay rack mounted and terminations are made on the rear of the Ethernet panel.
Installing the ADC ETP-64 Ethernet termination panel allows separate circuits to route individually
or grouped as needed by bringing all circuits out to the MDF.
Features
All connections made on rear side of ETP-64
64ea. 4-wire Ethernet ports from Central Office based equipment via 50 pin AMP (male/plug type)
connectors
64ea. 4-wire Ethernet ports (128 pair) to MDF via LSA-PLUS NT IDC terminal blocks
Internal wiring directly connects the equipment side to MDF side (no cross connect jumpering)
ETP-64 converts from 50 pin AMP type connector to individually paired circuits
Test access point for wire testing and troubleshooting of equipment independent of MDF wiring
w w w . a d c . c o m
+ 1 - 9 5 2 - 9 3 8 - 8 0 8 0
1 - 8 0 0 - 3 6 6 - 3 8 9 1

Advertisement

loading

Summary of Contents for ADC ETP-64

  • Page 1 The panel is relay rack mounted and terminations are made on the rear of the Ethernet panel. Installing the ADC ETP-64 Ethernet termination panel allows separate circuits to route individually or grouped as needed by bringing all circuits out to the MDF.
  • Page 2: Specifications

    Specifications published here are current as of the date of publication of this document. Because we are continuously improving our products, ADC reserves the right to change specifications without prior notice. At any time, you may verify product specifications by contacting our headquarters office in Minneapolis. ADC Telecommunications, Inc.