Setup - Toro Multi Pro 5800-D Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Media and Additional Parts
Description
Starter key
Operator's Manual
Engine owner's manual
Parts Catalog
Operator training materials
Screen filter
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
If you have questions or need additional information regarding the spray control system, refer to the
Operator's Manual supplied with the system.
Important:
This sprayer is sold without nozzles.
To use the sprayer, you must obtain and install nozzles. Contact your Authorized Toro Distributor for
information on the available boom kit and accessories.
After you install your nozzles and before using the sprayer for the first time, adjust the boom-bypass
valves so that the pressure and application rate remains the same for all booms when you turn 1 or
more booms off. Refer to Calibrating the Boom-Bypass Valves section in the Operation section.
Description
No parts required
No parts required
Qty.
–
–
Qty.
2
1
1
Read the manuals and watch the training materials before
operating the machine.
1
1
2
15
Use
Check the boom-hinge springs.
Remove the shipping bumper.
Use