Toro Multi Pro 5800-D Operator's Manual page 21

Sprayer Controls
1. Battery-voltage-warning
light
2. Oil-pressure-warning light
3. Glow-plug-warning light
4. Coolant-temperature-warning
light
Application-Rate Switch
The application-rate switch is located on the dash to
the right of the steering wheel
hold the switch forward to increase the application rate
(pressure), or press and hold it rearward to decrease
the application rate (pressure).
Pressure Gauge
The pressure gauge (Figure
dash. This gauge shows the pressure of the fluid in
the spray system in kPa and psi.
Master-Boom Switch
The master-boom switch is located on the left side of
the armrest. It allows you to start or stop the spray
operation. Press the switch to enable or disable the
spray system.
Figure 10
5. Pressure gauge
6. Tank-agitation switch
7. Right raise/lower-boom
switch
8. Right boom switch
(Figure 10). Press and
10) is located on the
9. Center boom switch
10. Left boom switch
11. Master-boom switch
12. Left raise/lower-boom
switch
Boom-Section Switches
The boom-section switches are located on the center
console in front of the armrest
each switch forward to turn the corresponding boom
section on and rearward to turn each off. When the
switch is in the O position, an icon appears on the
N
InfoCenter.
Note:
These switches affect only the spray system
when the master-boom switch is in the O
Pump Switch
The pump switch is located on the center console to
the right of the seat
forward to run the pump or rearward to stop the pump.
Important:
Engage the pump only when the
engine is at low idle to avoid damaging the pump
drive.
21
13. Pump switch
14. Application-rate switch
(Figure 10). Toggle
N
(Figure 10). Toggle this switch
g034371
position.