Toro Multi Pro 5800-D Operator's Manual page 79

5. Installing the Section-Manifold Valve (page
83)
6. Installing the Valve Actuator (page 84)
Removing the Valve Actuator
1. Move the machine to a level surface, set the
parking brake, stop the pump, shut off the
engine, and remove the key from the ignition
switch.
2. Remove the retainer that secures the actuator
to the manifold valve for the section valve or
agitation valve
Note:
Squeeze the 2 legs of the retainer
together while pushing it down.
Note:
Retain the actuator and retainer for
installation in Installing the Valve Actuator (page
84).
Section-Valve Actuator Shown (the agitation valve actuator
1. Actuator (section valve)
2. Retainer
3. Remove the actuator from the manifold valve.
Removing the Agitation-Manifold
Valve
1. Remove the clamps and gaskets that secure
the manifold for the agitation valve to the
agitation-bypass valve, pressure-filter head,
reducer coupling, and adapter fitting (agitation
throttle valve) as shown in
Note:
Retain the clamps, gaskets, quick
connect, and quick-connect pin for installation in
Installing the Agitation-Manifold Valve (page
79
(Figure 105).
Figure 105
is similar)
3. Stem port
Figure 106.
g032545
83).