Storage - Toro Multi Pro 5800-D Operator's Manual

3. Assemble the outlet fitting onto the lower
end-cap fitting of the manifold valve
A).
4. Secure the end-cap fitting to the outlet fitting by
inserting a retainer into the socket of the outlet
fitting (Figure 116
5. Align a gasket between the flanges of the
reducer coupling and the section-valve manifold
(Figure 116 B).
6. Assemble the reducer coupling, gasket, and
section-valve manifold with a clamp tightened
hand-tight (Figure 116
7. If installing the 2 left most section valves, align
a gasket between the flanges of the 2 adjacent
section-valve manifolds
8. Assemble the and 2 adjacent section-valve
manifolds and gasket with a clamp and tighten
the clamp by hand
9. If you loosened the mounting hardware for the
bypass valve, tighten the nut and bolt to 1017 to
1243 N∙cm (90 to 110 in-lb).
Installing the Valve Actuator
1. Align the actuator to the manifold valve.
2. Secure the actuator and valve with the retainer
that you removed in step
Valve Actuator (page
(Figure 116
A)
B).
(Figure 116 B).
(Figure 116 B).
2 of Removing the
79).

Storage

1. Position the sprayer on a level surface, set
the parking brake, stop the pump, shut off the
engine, and remove the key from the starter
switch.
2. Clean dirt and grime from the entire machine,
including the outside of the engine.
Important:
with mild detergent and water. Do not use
high-pressure water to wash the machine.
Pressure washing may damage the electrical
system or wash away necessary grease at
friction points. Avoid excessive use of water,
especially near the control panel, lights,
engine, and battery.
3. Condition the sprayer system as follows:
A. Drain the fresh-water tank.
B. Drain the spray system as completely as
possible.
C. Prepare rust inhibiting, non-alcohol
based, RV antifreeze solution per the
manufacturer's instructions.
D. Add the RV antifreeze solution to the
fresh-water tank and sprayer tank.
E. Run the sprayer pump for a few minutes
to circulate the RV antifreeze throughout
the spray system and any installed spray
accessories.
F. Turn the master boom and boom sections
on and spray out the nozzles until the RV
antifreeze is visible then turn the master
boom off.
G. Drain the fresh-water tank and spray system
as completely as possible.
4. Use the boom-lift switches to raise the booms.
Raise the booms until they have moved
completely into boom-transport cradle forming
the 'X' transport position and the boom cylinders
are fully retracted.
Note:
Make sure that the boom cylinders are
fully retracted to prevent actuator-rod damage.
5. Perform the following maintenance steps for
short-term or long-term storage
•
Short-term storage (less than 30 days),
clean the sprayer system; refer to
the Agitation and Section Valves (page
•
Long-term storage (longer then 30 days),
perform the following:
A. Clean the agitation valve and the 3
section valves; refer to
Agitation and Section Valves (page
84
You can wash the machine
Cleaning the
Cleaning
78).
78).