Toro Multi Pro 5800-D Operator's Manual page 26

Figure 16
1. Suction hose
3. Remove the hose and hose fitting from the
strainer housing (Figure
4. Pull the suction strainer out of the strainer
housing in the tank
Figure 17
1. Suction strainer
5. Clean the suction strainer with clean water.
6. Insert the suction strainer into the strainer
housing until the strainer is fully seated.
7. Align the hose and hose fitting to the strainer
housing at the top of the tank to the and secure
fitting and housing with the retainer that you
removed in step 2.
2. Retainer
16).
(Figure 17).
Inspecting the Tank Straps
Service Interval: Before each use or daily—Check
Important:
Over tightening the tank strap
fasteners can result in deforming and damaging
the tank and straps.
1. Fill the main tank with water.
2. Check to see if there is any movement between
the tank straps and the tank
g002257
1. Rear tank strap
2. Bolt
3. Flanged locknut
3. If the tank straps fit loose to the tank, tighten the
flanged locknuts and bolts at the top of straps
until the straps are flush with the surface of the
tank (Figure
g005491
Note:
Do not over tighten the tank strap
hardware.
26
the tank straps.
(Figure
Figure 18
4. Forward tank strap
5. Front of the machine
18).
18).
g028263