Nozzle Size And Approximate Depth Chart - Toro Hydroject 3010 Service Manual

Depths and Nozzle Configurations: All nozzles are identified with numbers indicating the drill size of the orifice. The
standard configuration is 11 nozzles producing depths of 4 to 6 inches depending on turf conditions. Blocked nozzle
locations are obtained by reversing the nozzle check valve ball and spring. See nozzle size chart and illustrations be-
low:
IMPORTANT: Use only nozzle configurations shown or damage to the machine may occur.

NOZZLE SIZE AND APPROXIMATE DEPTH CHART

Part No. Drill Size Decimal Size
86–8130 #56
86–8131 #53
86–8133 #46
*
Use only with varied size configurations
Aluminum Washer is required with any nozzle change:
Part no. 86–8150
OPTIONAL STAGGERED SIZE NOZZLE CONFIGURATION
Part No. Drill Size Decimal Size
86–8130 #56
86–8133 #46
Aluminum Washer is required with any nozzle change:
(S/N 29999 & Below) Part no. 80–6680
Part no. 86–8150
**Additional nozzles may be blocked to compensate for pump wear.
Hydroject 3010
Metric Size
(inch) (mm)
.0465 1.181
.0595 1.511
.0810 2.057
Metric Size
(inch) (mm)
.0465 1.181
.0810 2.057
Page 6 – 2.1
Quantity of Nozzles
Open
Blocked **
* *
11 0
6 5
Quantity of Nozzles
Open
Blocked **
6 and 0**
5 0**
Rev. B
Approx.
Depth
*
4–6"
6–8"
Approx.
Depth
3–4"
6–8"
Specifications