AEG 30006VL-WN User Manual page 27

A
Minimum distances
Dimension
A
12.3 Levelling of the appliance
Use small feet on the bottom of
appliance to set the appliance top
surface level with other surfaces.
12.4 Anti-tilt protection
CAUTION!
Install the anti-tilt protection
to prevent the appliance
from falling under incorrect
loads. The anti-tilt
protection only works when
the appliance is put in a
correct area.
Your appliance has the
symbols shown on the
pictures (if applicable) to
remind you about the
installation of the anti-tilt
protection.
mm
685
CAUTION!
Make sure you install the
anti-tilt protection at the
correct height.
Make sure that the surface behind the
appliance is smooth.
1. Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 176 mm
down from the top surface of the
appliance and 24 mm from the left
side of the appliance into the circular
hole on the bracket. See the
illustration. Screw it into the solid
material or use applicable
reinforcement (wall).
3. You can find the hole on the left side
at the back of the appliance. See the
illustration. Put the appliance in the
middle of the space between the
cupboards (1). If the space between
the bench cupboards is larger than
the width of the appliance, you must
adjust the side measurement to
centre the appliance.
ENGLISH 27