Table of Contents
Advertisement
The remote control handle must be in the neutral position to start the engine.
b
Digital Throttle and Shift
Digital Throttle and Shift (DTS) operating instructions are provided in a separate manual. Refer to Mercury Diesel's SmartCraft
and DTS Operator's Manual.
Electrical System Overload Protection
Failure to protect wiring with an appropriate fuse can damage the wiring and start a fire. When installing any accessories, we
recommend using a Mercury accessory kit. Always use the appropriate fuse to protect wiring.
Fuses
Fuses protect individual circuits from an overload. If an electrical overload occurs, a fuse will burn out. Find and correct the
cause for the electrical overload before replacing the fuse. Always replace a burned out fuse with a fuse that is the same
current rating. Never install a higher current rated fuse.
a
Two fuses are located on the engine. To access these fuses, remove the two screws securing the engine control module cover.
Be certain to replace an open fuse only with one of the same current rating.
The remaining fuses are located in the vessel adapter assembly (refer to your boat owner's manual for location) and on the rear
side of the control unit of the individual instrumentation.
a
90-8M0133568
JUNE 2017
eng
a
c
d
b
b
28619
b
c
54638
Section 1 - Getting to Know Your Power Package
a -
Neutral
b -
Increase engine RPM
c -
Forward gear
d -
Reverse gear
51014
CAUTION
!
Identifying a burned out fuse
a -
Good fuse
b -
Burned out fuse
Engine control module
a -
25‑amp fuse
b -
15‑amp fuse
c -
Gear lubrication monitor (sterndrive only)
Page 9
Advertisement
Table of Contents
Troubleshooting
