Section 1 - Getting to Know Your Power Package
2.
Trim switch (if equipped) ‑ When the power trim switch is activated on the ERC handle, the DTS command module senses
a closed circuit for either up or down trim. The DTS command module formulates a signal and sends it to the PCM. The
PCM closes the ground circuit to the up or down trim relay.
b
a
d
3.
Detent tension adjustment screw ‑ This screw can be adjusted to increase or decrease the effort to move the control
handle out of detent positions. Turning the screw clockwise will increase tension. Adjust to the desired tension.
4.
Control handle tension adjustment screw ‑ This screw can be adjusted to increase or decrease the tension on the control
handle. This will help prevent unwanted motion of the remote control handle in rough water. Turn the screw clockwise to
increase tension and counterclockwise to decrease tension. Adjust to the desired tension.
a
b
NOTE: The control handle tension and detent tension screws may require periodic maintenance adjustment.
Special Digital Throttle and Shift (DTS) Features
The DTS system features several alternate operational modes for the electronic remote control (ERC) levers.
Page 10
a -
Forward
b -
Neutral
c -
Reverse
d -
Trim switch
c
52360
a -
Caps (2)
b -
Detent tension adjustment
c -
Control handle tension adjustment
c
52313
a
Slim binnacle ERC
b
STOP/
START
h
N
c
g
DOCK
TRANSFER
d
THROTTLE - ONLY
e
f
52365
90-8M0113859
DECEMBER 2015
eng