Driveshaft Extension Models; Maintaining Torques; General Torque Specifications - Mercury TDI 3.0L Operation And Maintenance Manual

Tube Ref No.
SAE Engine Oil 30W
80

Driveshaft Extension Models

1. Lubricate the transom end grease fitting and engine end grease fitting by applying approximately 10–12 pumps of grease
from a typical hand‑operated grease gun.
2. Lubricate the driveshaft grease fittings by applying approximately 3–4 pumps of grease from a typical hand‑operated
grease gun.
b
a
a - Driveshaft grease fittings
b - Transom end grease fitting
c - Engine end grease fitting
Tube Ref No.
Extreme Grease

Maintaining Torques

General Torque Specifications

The following torque table is a general guideline for fasteners unless an installation process in the manual lists a specific torque
value. Review the manual to identify if the fastener requires a specific torque value.
Fastener size
M6
M7
M8
M10
M12
90-8M0133568 JUNE 2017
eng
Description
Description
Transom end grease fitting, engine end grease fitting, driveshaft grease
Where Used
Shift cable pivot points and guide contact surfaces
Where Used
fittings
Torque value
10 Nm (88.5 lb‑in.)
15 Nm (132.7 lb‑in.)
25 Nm (18.4 lb‑ft)
40 Nm (29.5 lb‑ft)
60–68 Nm (44.2–50.2 lb‑ft)
Section 4 - Maintenance
Part No.
Obtain Locally
c
a
17014
Part No.
8M0071842
Page 53