Troubleshooting - Tecway Kidde Dozer Manual

11. TROUBLESHOOTING

If you have any problem in installing or using the machine, we
recommend that you first check the following table for possible
cause of the problem and solution before asking for technical
support:
the coin mech is bad
the wire of light's control is loose.
The flash
lights do not
the light is bad
light up
the lights drive board failure
the circuit of motor is blocked
The motor
the motor-driven inverter fault
has no
the start capacitor of motor is bad
movement
the motor is bad
the plane stops check the sensor
The plane
wires, can not get through
keep moving
up and down
the plane stops check the sensor is
can not stop.
broken.
the circuit of direction encoder is
Directions
blocked
control failure
the encoder is bad
the monitor power line is loose
the monitor signal cable is not
The monitor
connected
has no display
the main board is bad
the mointor is bad
the wire of speaker is loose.
Have no
the volume is too low.
sound.
the speaker is bad.
no A C110V /220V input
No movement
Leakage protection switch is off.
for the whole
no output voltage of power supply.
machine
the main board is bad.
replace the coin mech
check the connection of light's control.
replace the light.
maintain or replace the lights drive board
check the connection of motor
reset or maintain the inverter
replace the start capacitor of motor
replace the motor
connect and check the cable of the sensor
change the testing sensors
check and connect the circuit of direction
encoder
replace the encoder
reconnect the monitor power line
connect the monitor signal cable
maintain or replace the main board.
replace the monitor
check the connection of speaker.
adjust the volume on the setting interface.
check and replace the speaker.
check the connection
please check if there is a short circuit.
repair or replace the power supply.
replace the main board.