Resetting To Factory Default Settings - Motorola Avigilon H4 Series Installation Manual

Resetting to Factory Default Settings

If the device no longer functions as expected, you can choose to reset the device to its factory default
settings.
Use the firmware revert button to reset the device. The firmware revert button is shown in the following
diagram:
Note: Be careful not to scratch the dome bubble.
Figure 4: The firmware revert button between the status LEDs.
1. Ensure the camera is powered on.
2. Remove the dome cover.
3. Using a straightened paperclip or similar tool, gently press and hold the firmware revert button for
two seconds.
4. Re-install the dome cover.
CAUTION — Do not apply excessive force. Inserting the tool too far may damage the camera.
Resetting to Factory Default Settings 19