Table of Contents
Advertisement
Before you begin
• Make sure you have the correct type of rack and know where to mount the outer rails, as described
in
Preparing the Rack and Rails for Mounting the Device
• Make sure you have the following items, which were shipped with the device and are used to
mount the outer rails to the rack
12):
–
–
–
–
Procedure
1. Connect the long and short outer rails to each other by sliding the knob on the short rail
Installation Guide for Avaya Scopia
(Figure 4: Preparing the parts required to mount the rails
Two long outer rails
Two short outer rails
Two flat-head long screws (Phillips cross recessed flat-head machine screws M5x12mm)
Two brackets (finishing washers M5)
Figure 4: Preparing the parts required to mount the rails
through the rounded end of the slot on the long rail
on page 13).
®
Application Server Version 2
on page 9.
(Figure 5: Connecting the two outer rails
Setting up the Device | 12
on page
Advertisement
Table of Contents
