How To Remove The Fan Tray 0 Cable - Sun Microsystems Sun Fire V480 Parts Installation And Removal Manual

3. Press the back panel LED flex circuit onto the back panel.
Be sure the back panel slot is covered with the LED assembly.
Back panel LED flex circuit
4. Peel off the backing paper from the flex circuit cable end and press it onto the
inside of the chassis.
5. Connect the P2 cable end of the system control switch to the flex circuit cable end.
What Next
Complete these tasks:
"How to Install the PCI Access Panel" on page 92
"How to Slide the System Into the Cabinet" on page 30
"How to Power On the System" on page 18

How to Remove the Fan Tray 0 Cable

Before You Begin
Complete these tasks:
"How to Power Off the System" on page 22
"How to Slide the System Out of the Cabinet" on page 25
"How to Avoid Electrostatic Discharge" on page 39
"How to Remove the Power Supply Access Panel" on page 44
166 Sun Fire V480 Server Parts Installation and Removal Guide • December 2002