Preparing To Service The System - Sun Microsystems Sun Fire V480 Parts Installation And Removal Manual

2
C H A P T E R

Preparing to Service the System

This chapter describes service procedures. It contains the following sections:
"Tools Required for Installation and Service" on page 18
"How to Power On the System" on page 18
"How to Power Off the System" on page 22
"How to Initiate a Reconfiguration Boot" on page 23
"How to Slide the System Out of the Cabinet" on page 25
"How to Slide the System Out of a Fully Populated Cabinet" on page 28
"How to Slide the System Into the Cabinet" on page 30
"How to Remove the System From the Cabinet" on page 32
"How to Install the System Into the Cabinet" on page 35
"How to Avoid Electrostatic Discharge" on page 39
Note - If you are servicing a system installed in a 2-post rack, see Appendix A.
Guidelines
Be sure to keep the following guidelines in mind:
Except for removing and installing power supplies and disk drives, this system
must be serviced by qualified service providers.
Power supplies are hot-swappable. For information about hot-swapping, see
"About Hot-Swappable and Hot-Pluggable Components" on page 44.
Internal disk drives are hot-pluggable. For information about hot-plugging, see
"About Hot-Swappable and Hot-Pluggable Components" on page 44.
For servicing any other parts internal to the system, you must first power off the
system. See "How to Power Off the System" on page 22.
17