Communication Operation And Setting; Wiring And Configuration Of Pu Connector - Mitsubishi F700 Series Instruction Manual

Communication operation and setting

4.19 Communication operation and setting

Purpose
Communication operation from PU
connector
Communication operation from RS-
485 terminals
Restrictions on parameter write
through communication
Operation selection the at a
communication error
Operation by PLC function

4.19.1 Wiring and configuration of PU connector

Using the PU connector, you can perform communication operation from a personal computer etc.
When the PU connector is connected with a personal, FA or other computer by a communication cable, a user program
can run and monitor the inverter or read and write to parameters.
(1) PU connector pin-outs
CAUTION
 Pins No. 2 and 8 provide power to the operation panel or parameter unit. Do not use these pins for RS-485 communication.
 Do not connect the PU connector to the computer's LAN board, FAX modem socket or telephone modular connector. The
product could be damaged due to differences in electrical specifications.
204
Parameter that must be Set
Initial setting of computer link
communication (PU connector)
Initial setting of computer link
communication (RS-485
terminals)
Modbus-RTU communication
specifications
BACnet MS/TP protocol
Communication EEPROM write
selection
Stop mode selection at
communication error
PLC function
Pin Number
Inverter
(Receptacle side)
Front view
8)
to
1)
Pr. 117 to Pr. 124
Pr. 331 to Pr. 337, Pr. 341, Pr. 502,
Pr. 779
Pr. 331, Pr. 332, Pr. 334, Pr. 343,
Pr. 502, Pr. 549, Pr. 779
Pr. 331, Pr. 332, Pr. 390, Pr. 549,
Pr. 726 to Pr. 729
Pr. 342
Pr. 502, Pr. 779
Pr. 414, Pr. 415, Pr. 498,
Pr. 506 to Pr. 515,
Pr. 826 to Pr. 865
Name
1) SG

2) Operation panel power supply
3) RDA
4) SDB
5) SDA
6) RDB
7) SG

8) Operation panel power supply
Refer to
Page
209
227
242
211
211
255
Description
Earth
(connected to terminal 5)
Inverter receive+
Inverter send-
Inverter send+
Inverter receive-
Earth
(connected to terminal 5)