Pid Display Bias/Gain Setting Menu - Mitsubishi F700 Series Instruction Manual

4.24.1 PID display bias/gain setting menu

The parameters, which need to be set first when FR-PU07-01 is connected, are displayed as a list. The bias and
gain for the PID display (Pr. 934 and Pr. 935 ) and setting for Pr. 999 Automatic parameter setting can be set in these
simple steps.
Pressing while the FR-PU07-01 is in the monitor mode brings up the dedicated menu screen.
Pr. 999 is displayed at the first turn ON of the inverter, or at the first turn ON after parameter clear. After
Pr. 999 is set, Pr. 934 and Pr. 935 are displayed on the dedicated parameter menu.
(This function is valid under PID control. If
parameter setting mode.)
PIDset
934 PID bi as
935 PID gai n
934 PID bi as
935 PID gai n
Example when setting value "2" is set once in Pr. 999
Display of the dedicated parameter menu differs depending on Pr. 999 setting and PID control condition.
Condition
Pr.999 setting
Never set before
1 (normal PID)
2 (extended PID)
REMARKS
The parameters, which are displayed in the dedicated parameter menu, can be always read regardless of the Pr. 160 setting. For
writing, the same restriction as for the normal parameters is applied.
is pressed while PID control is invalid, the monitor goes into the
0. 0
P S I
- - - STOP HAND
Monitor mode
PrSET:PrSET
Dedicated menu
PrSET:PrSET
Dedicated menu
When PID control is unavailable
(Pr. 128 < 50, and Pr. 753 < 50, and
X14 signal not assigned)
Pr. 999
No display
Pr. 934, Pr. 935
SETTING MODE
0~ 9:S er Pr. No.
S elec t O per
Parameter setting mode
to
SETTING MODE
P r . N o . .
to
133
<R E AD >
Parameter setting mode
934 P ID bias
9999
Set <WR ITE >
E xt <R E AD >
Parameter setting screen (Pr.934)
Dedicated parameter menu
(Pr. 128
Setting of FR-PU07-01
When PID control is available
 50, or Pr. 753  50, or
X14 signal assigned)
Pr. 999, Pr. 934, Pr. 935
Pr. 934, Pr. 935
Pr. 934, Pr. 935
4
315