Operation; Crushing Hard Drives; Crushing Ssds (With Optional Ssd Kit); Crushing Dlt Tapes - SEM 0100 Operation And Maintenance Manual

Hdd/ssd crusher

Hide thumbs Also See for 0100:

Table of Contents

4.) Operation

Warning: Unit is shipped ready to destroy 1" hard drives. It is

recommended to reset if punching 1.65" hard drives. Refer to the

section Changing Settings and Maintenance for more.

1) Lift handle to insert hard drive.

Note: It is recommended to punch the hard drives on the PC board

side. Do not try to punch center hub of hard drive. The device is

designed to punch the platters inside the drive

2) Pull the handle down until it punctures the hard drive. Do not force the handle once it stops.

Note: Anvil will not penetrate through the entire hard drive. The Model 0100 hard drive crusher pierces and

deforms hard drives to disable the drive.

3) Pull the handle up to remove hard drive. If more deformation is needed, turn hard drive 180° to puncture the

opposite side.

1) Remove long handle and insert the short handle.

2) Lift handle to insert the metal press plate and UHMW SSD wear

plate. The metal plate should insert so that it does not extend past

the edge of the crusher.

Note: UHMW SSD wear plate may be flipped and rotated until

entire plate is extensilvely worn. Replacement wear plates are

available. Contact SEM customer care.

3) Lift handle and insert PC board. Pull handle down and crush each

memory chip. Repeat to each individual chip on the board.

1) Lift handle to insert DLT tape.

Note: It is recommended to punch the top side in the center of

tape.

2) Pull or push handle down to penetrate DLT tape.

Warning: DLT tape is not considered destroyed. Only the metal is

removed to make the tape inoperable.

508.366.1488 | www.semshred.com

Table of Contents