Start Up Tip Sheet; Before Operation; Normal Operation; To Operate In Manual Mode - SEM 1400 Series Operation And Maintenance Manual

5. Start Up Tip Sheet

5.1 Before Operation:

1. Ensure proper size security screen(s) is in place.
2. Ensure the waste container is not full and is in its proper position.
3. Shake the dust filter bag with the fan motor off.

5.2 Normal Operation:

1. Ensure MCP is set to automatic.
2. Start preshredder.
3. Press automatic start on MCP.
4. Press conveyor start.
5. Feed recommended volume of material.
6. Never feed material that is wet, greasy, or contains metal.
7. Periodically check waste level and rake materials into lower area of the container to prevent blockage.
8. Run system five minutes after last feed lot, then press automatic stop.

5.3 To Operate in Manual Mode:

1. Start air lock and fan system motor(s).
2. Start the preshredder. Start the disintegrator.
3. Start conveyor.
4. See items 5-8 above.

5.4 Periodically Check:

1. Knives (sharpen or replace knives as required).
2. Belt tension (lower belt span should have 1/2" vertical play).
3. Filter bin and tubes to prevent clogging.
4. Ductwork for air tight connections.
5. Rotor bearings and motor bearings for lubrication.
6. Rotary air lock valve (if used). Gear box to be ½ full with gear oil and chain and bearings lubricated.
7. DS Units: Check oil level in the preshredder reducer (approx. halfway up sight glass).
11
508.366.1488 | www.semshred.com