Table of Contents
Advertisement
After the media has been shredded and gone through the cutting unit, the blades will continue to rotate for
approximately ten seconds. For continuous shredding, insert the next piece of media to be shredded within
ten seconds of the previous material.
To stop the shredding process, press the Stop/Reverse/Restart button. The cutting unit will cease operation.
If the media has gone through the cutting unit, the display should indicate READY TO SHRED with the
gradation lamp illuminating blue. If media remains in the chute, the display should indicate AUTO RUN
SUSPENDED, the gradation lamp flashes blue, and an alarm sounds every five seconds.
2.3 Reverse Operation
Reverse operation is possible during the three following displays:
1. READY TO SHRED indicator and a solid blue gradation lamp.
2. AUTO RUN SUSPENDED indicator and a flashing blue gradation lamp.
3. READY TO SHRED indicator and a flashing red gradation lamp.
Press the Stop/Reverse/Restart button and hold it down. While you are pressing the button, the cutter will
rotate in the reverse direction. The gradation lamp will illuminate pink while running in reverse.
2.4 Discarding Waste
It is important to regularly check waste bin every 100 cards or tags and dispose of the waste properly. Do
not wait for the discard waste indicator to illuminate, as it is meant as a safety feature only.
When the waste basket is full, the display DISCARD WASTE will flash while an alarm sounds and the
gradation lamp flashes green. The shredder will level the media automatically for about ten seconds across
the waste basket.
Caution: Do not open the cabinet door during this operation.
9
508.366.1488 | www.semshred.com
Advertisement
Table of Contents
