Jumper Settings - Siemens IM 328–N Description

Description
2.1 Hardware of the module 6FC5 012–0CA03–0AA0
2.1.1
Selecting the
control system
(S2.5, S2.6, S2.7
and S2.8)
2
Setting of address
range (number of
input and output
bytes) (S2.1 and
S2.2)
Setting the base
address
(S3.1 to S3.8)
2-2

Jumper settings

The module can be used in the control systems listed. The control type must
be set with switches S2.5, S2.6, S2.7 and S2.8 as follows:
SINUMERIK 805SM
SIROTEC ACR 20
SINUMERIK 840C
Note
The IM 328–N module can only be used for SINUMERIK 805SM in the
central controller.
Switches S2.1 and S2.2 must be set according to the table below in order to
set the address range of 4, 8, 16 or 32 input or output bytes.
Address range
4 bytes
8 bytes
16 bytes
32 bytes
Note
Address range of, for example, 4 bytes means that 4 input bytes and 4 output
bytes are available with the same base address.
The following switches are used to set the module numbers (base address)
S3.1 to S3.8
S3.2 to S3.8
S3.3 to S3.8
S3.4 to S3.8
S2.5
OFF
ON
ON
S2.1 in position
OFF
OFF
ON
ON
for an address range of
for an address range of
for an address range of
for an address range of
6ZB5 430–0BH02–1AA0 Siemens AG 1996 All Rights Reserved
07.96
S2.6 S2.7 S2.8
ON OFF ON
ON ON ON
ON ON ON
S2.2 in position
OFF
ON
OFF
ON
4 bytes
8 bytes
16 bytes
32 bytes
SINUMERIK 805SM / 840C (BS)