3.2.1 Notes On Parameterization Of The Slaves - Siemens IM 328–N Description

Description 07.96
In the INDIVIDUAL DIAGNOSTICS screen form, you can obtain the follo-
wing information about the required station:
Station number
Station type
Station designation
Station status
Device and ID–related diagnostics
((Block 3))
Reference: /1/, SIMATIC S5 ET 200 Distributed I/O System
((S. 3–5))
3.2 Description of the DP standard slaves
Note
This section only applies if
The IM 328–N module is used with the order number: ...
and
The X999 jumper is assigned for operation as a SINEC L2–DP slave (standard
DP) (see Section 2.1.1)

3.2.1 Notes on parameterization of the slaves

Here are some notes that must be observed when the IM 328–N is used as a
standard slave in the ET 200 Distributed I/O System.
For example, the master IM 308–B or IM 329–N are used.
Prerequisites for slave parameterization
If the IM 308–B or IM 329–N module is the master
PG/PC with COM ET 200 (V4.x)
Type file for IM 328–N (see Section 3.1.1)
ET 200 system parameters
Note
About the system parameter BUS PROFILE:
Select the bus profile "DP standard" or
"DP/FMS operation"
About the baud rate:
Baud rates up to 1500 kBaud are possible.
Configuration
There is a separate configuration screen form to configure the slave interface
of the IM 328–N. To make this screen form available, the appropriate type file
must be installed (see Section 3.1)
((S. 3–6))
6ZB5 430–0BH02–1AA0 Siemens AG 1996 All Rights Reserved
3-10
SINUMERIK 805SM / 840C (BS)