Siemens IM 328–N Description page 68

07.96
((Block 1))
Selecting the master type
After input of the new program file and confirmation, e.g., of softkey F1 in the
function selection screen form, you are prompted to select the master type.
...
Fig. 3–1 Selecting the master type
After you have selected the master type, the following functions are available:
((Block 2))
TRANSFER functions
The TRANSFER FUNCTIONS screen form permit the following for a me-
mory module:
Programming of a memory module with system parameters and configuration
data for the IM 308–B
Read–in of a memory module into a program file
Comparison of the creation data from program file and memory module.
Moreover, you can transfer the configuration data created with COM ET 200
to a SINEC L2–DP master (such as the IM 329–N)
((Block 3))
Address assignment and system documentation
This screen gives you information about the current configuration status, e.g.
via the
n
n
n
tain the information:
Query:
In which slot is the module inserted?
What addresses to the inputs and outputs have?
n
each (e.g. the P range):
Which inputs and outputs are assigned to which stations?
To which slot and to which module type is each input and output assigned?
You can also print out the current configuration status.
((S. 3–4))
((Block 1))
From the STARTUP/TEST screen form you automatically enter the screen
form MODULE SELECTION or STATUS/FORCE.
In the STATUS/FORCE screen form, you can see the signal condition of the
inputs of all selected modules. It is also possible to force the outputs of the
modules selected.
((Block 2))
Siemens AG 1996 All Rights Reserved
SINUMERIK 805SM / 840C (BS)
Set ET 200 system parameters
Assigned station numbers
Station–oriented address assignment for one station you ob-
Address assignment range–oriented for one address range
6ZB5 430–0BH02–1AA0
Description
3-9