Siemens IM 328–N Description page 70

07.96
Station type "IM 328–N slave DP" must be used to configure station type IM
328–N, DP slave.
((Tabelle: ))
Address range
4 bytes
8 bytes
16 bytes
32 bytes (2 – 16 bytes)
The address IDs follow DIN E 19245 Part 3.
((S. 3–8))
Note:
On the SINUMERIK 840C, I/O modules that have just been slotted in are not
recognized until a cold restart of the control is performed.
For the IMI 308–B: Write to the memory module
For the IM 329–N, master: perform DOWNLOAD
Reference: /7/, SIROTEC ACR20, SINUMERIK (=%SM/840C
Link to SINEC L2–DP with module IM 329–N
((S. 3–14))
Normal operating state
((Tabelle))
Normal operation is displayed via the status display as follows:
grün
rote
ein
aus
Bedeutung = Meaning
Normal operation, slave is in cyclic mode
((Tabelle weiter unten, wie oben mit: ))
Fault during data transmission
((S. 3–16))
3.2.6
General notes on diagnostics
The STEP 5 program of the IM 328–B master can request and evaluate the
following diagnostics messages via the IM 328–N slave:
((Tabelle: ))
((linke Spalte: ))
Diagnostics type
Siemens AG 1996 All Rights Reserved
SINUMERIK 805SM / 840C (BS)
Address ID 0 Address ID 1
((etc. dez = dec))
green
red
on
off
Diagnostics functions in the S5 program of the master
6ZB5 430–0BH02–1AA0
Description
3-11