Siemens IM 328–N Description page 63

Description
((S. 2–4))
Base address for 16–byte address range
Switch S2.1 = ON and S2.2 = OFF
((Tabelle: ))
Base address
Significance
x: Switch position of no significance
Base address for 32–byte address range
Switch S2.1 = ON and S2.2 = ON
((Tabelle wie oben))
((S. 2–5))
((Block 1))
Switches S2.3 and S2.4
These switches are assigned as follows:
Switch Position
Jumpers X999
With this jumper you can set the type of communication with which the mo-
dule is to be operated.
Table 3–1 Setting for the type of communication
Meaning
Module is operated as a SINEC L2–DP slave (standard DP) (see Section 3.2)
Module is operated as a SINEC L2–DP slave up to V 3.x (see Section 3.3)
The module behaves like the ... module.
I/O ranges
In assigning the slaves, please note that the following I/O ranges are available
on the SIROTEC ACR 20, SINUMERIK 805SM and SINUMERIK 840C con-
trols:
Inputs
Outputs
Physical interface without process image
For the allocation of the I/O range for each control see:
((S. 2–6))
Reference.
Interface Description, Part 2 – Connection Conditions
Reference:
Note
The I/O range must be addressed without gaps with SIROTEC ACR 20
3-4
((EB = IB; bis = to; AB = QB; E = I; A = Q))
/3/, SINUMERIK 805SM, –TW
/4/, SIROTEC ACR 20, Configuration Instructions
6ZB5 430–0BH02–1AA0 Siemens AG 1996 All Rights Reserved
07.96
SINUMERIK 805SM / 840C (BS)