Table of Contents
Advertisement
TrafficView Version 1.00
4.10.5.3.3
Flight recorder
If Flarm has flight recorder, TrafficView can send to Flarm all information about pilot and
aircraft. This data will be included in the header of IGC file from Flarm.
4.10.5.3.4
PF IGC readout
Pressing to this menu, TrafficView will send command to PowerFlarm, to copy IGC file to
USB stick that is plugged in PowerFlarm.
This function works only when PowerFlarm is connected.
4.10.5.3.5
PF pilot event
Pressing to this menu, TrafficView will send command to Flarm with pilot event message,
which will be recorder in the IGC file
This function works only with Flarm connected and with IGC option.
4.10.5.3.6
FLARM info
All available information about connected Flarm unit.
4.10.5.3.7
FLARM licenses
In this page user can see all options that are active or available for connected Flarm device.
Value
AUD
AZN
BARO
BAT
DP2
ENL
IGC
OBST
TIS
SD
UI
USB
XPDR
RFB
GND
4.10.5.4
NMEA test
This screen is only for troubleshooting so that user can identify the communication problem.
If at least one indicator is green communication is ok. To get all green, please check Flarm
configuration, if NMEA output is configured properly.
Description
Audio output connection
Alert Zone Generator
Barometric sensor
Battery compartment or built in batteries
Second Data Port
Engine noise level sensor
Device can be IGC approved
Device can give obstacle warnings if database
is installed and license is valid
Interface for Garmin TIS
Slot for SD cards
Built-in UI (display, possibly button/knob)
Slot for USB sticks
SSR/ADS-B receiver
Second radio channel for antenna diversity
Device can operate as receive-only ground
station
Page 16 of 22
August 2019
Advertisement
Table of Contents
