Nmea Output - LXNAV LX8000 User Manual

LX8000 (LX8080) Version 2.6
The same applies to the Airport checkbox.
displayed.
If the Task checkbox is checked the task will be synchronised with the other device.
When flying an assigned area task it is worth not having the task checkbox
checked. This will allow one pilot to play with "what if" scenarios. Once a proper
direction is found you can send the task to the other device using the SEND
action in task mode.
5.1.12.6 AHRS
When AHRS device is connected to the system, this menu is used to calibrate AHRS for
installation error.
Place you glider in levelled position and press LEVEL button. You can also modify pitch only,
if you rotate PAGE UP/DOWN rotary knob.
5.1.12.7

NMEA Output*

The LX8000 is capable of outputting position data sentences in NMEA format for use by
other devices.
Data is divided into three groups:
•
GPS data will output all GPS-related data such as time, longitude and altitude.
•
LX8000 data will output all variometer-related data such as vario, MacCready and
ballast.
•
Flarm data will output all Flarm-related data.
The NMEA baud rate will be always 19200 bps; any other settings are ignored.
The message
Page 47 of 110
September 2011
"Airport target received"
is