Table of Contents
Advertisement
TrafficView Version 1.00
4.10.3 Warnings
In this menu we can manage with all warnings. We can globally enable or disable all
warnings. Enable individually urgent, important and low-level alarms.
Dismiss time is a time in seconds, when same warning will appear again after dismissing it.
If we don't want any Flarm warnings immediately after take-off, we can check no warnings
for first 3 minutes.
The warnings are classified into three levels (See Flarm manual for details on
www.flarm.com)
•
First level (Low) approximately 18 seconds before predicted collision.
•
Second level (Important) approximately 13 seconds before predicted collision.
Third level (Urgent) approximately 8 seconds before predicted collision.
•
4.10.4 Obs. Zones
This menu is for setting start, finish and waypoint sectors, their shapes and other properties.
4.10.5 Hardware
4.10.5.1
Communication
Only communication speed can be set in this menu. Default setting for all Flarm units is
19200bps. The value can be set between 4800bps and 115200bps.
4.10.5.2
Traffic sounds
In the Sounds setup menu volume settings for the LXNAV TrafficView and alarms settings
can be modified.
Volume The sounds slider changes the alarm volume.
•
Beep on traffic TrafficView will notify with short beep a presence of a new Flarm
•
object.
Beep on low alarm TrafficView will beep on low level alarms triggered by Flarm.
•
Beep on important alarm TrafficView will beep on important level alarms triggered
•
by Flarm.
Beep on urgent alarm TrafficView will beep on critical level alarms (collision)
•
triggered by Flarm.
4.10.5.3
Flarm
On this page, we can see information about Flarm device and do some configuration of the
flight recorder, Flarm and aircraft.
Those settings will work only if TrafficView is the only device communicating with
the Flarm. If other devices are connected (Oudie for example), there will be a
conflict between transmit lines of RS232 from Oudie and FlarmView and
communication will not work.
4.10.5.3.1
Flarm config
In this menu are all range setups for Flarm and ADSB receiver.
4.10.5.3.2
Aircraft config
In Aircraft config menu, user can change the type of aircraft and ICAO address.
Page 15 of 22
August 2019
Advertisement
Table of Contents
