Nmea Output; Engine - LXNAV LX90 Series User Manual

Rev #23
5.1.11.12

NMEA Output

The main display unit is capable of transmitting position data sentences in NMEA format for
use by other devices.
Port defines on which serial interface data will be transmitted.
transmission speed. Data is divided into three groups:
GPS data will output all GPS-related data such as time, longitude and altitude.
•
LXNAV data will output all Variometer-related data such as vario, MacCready and
•
ballast.
Flarm data will output all FLARM-related data.
•
You can use at once only one NMEA output port (PC or FLARM or PDA).
IF you have an external FLARM and you want to connect FLARM displays to the
existing FLARM Port on the LX, you have to pay attention that on the NMEA port
you have selected FLARM and that both PFLAU and PFLAA sentences are enabled.
A PDA can be connected to the LX80/90xx system through the NMEA bridge or
via the EXT.(PC) port.
NMEA data is available also on the FLARM display port on the main display unit
and rear display unit at 19200bps. However only FLARM data and GPS data are
available.
5.1.11.13

Engine *

Use this menu when the system is installed into glider with engine. The current engine
noise level is shown as a progress bar. If an external MOP sensor is installed also the MOP
level will be shown.
Version 7.10 December 2019
Baud rate defines