Automatically Turn Off Nano4, When Flight Is Finished; Bluetooth; Nmea Output; Using Bluetooth Or Serial Interface - LXNAV NANO4 Manual

Version 1.05

7.2.2.4 Automatically turn off Nano4, when flight is finished

This option is very useful for NANO
If this option is enabled, the NANO
finished.

7.2.2.5 Bluetooth

Check the Enable Bluetooth checkbox if you want to turn it on. By default Bluetooth is
disabled.
When Bluetooth is enabled, the NANO4 will consume more power and the total
endurance of a new and charged battery will reduce approximately to 14 hours.

7.2.2.6 NMEA output

Check Enable NMEA output to output NMEA data. The NANO
NMEA sentences GPGGA; GPRMC, LXWP0 every second and LXWP1 once per minute.
NMEA can be output to either the serial interface or Bluetooth but not to both
simultaneously.
Change the NMEA baud rate, if you want to output NMEA at different baud rates.
7.3

Using Bluetooth or serial interface

Flight declarations can also be uploaded using the serial interface or Bluetooth (See chapter
7.4.1 for Bluetooth pairing). The NANO
When connecting through the serial interface, you should use the same baud rate
as is set for NMEA output on the NANO
When connected through Bluetooth baud rates are not important.
Please refer to the manual for the software used to upload flight declarations. (E.g. SeeYou
Mobile)
4
when installed more or less permanently into the glider.
4
will automatically switch off 30 minutes after the flight is
4
must be running in normal operating mode.
4
.
Page 50 of 54
May 2017
4
will transmit the following