Installation Checklist & Record; Installation & Commissioning Checklist - Rinnai Slimfire 252 Operation & Installation Manual

INSTALLATION CHECKLIST & RECORD
INSTALLATION & COMMISSIONING CHECKLIST
Instruct customer on Ultima II operation and ensure the customer understands the content of this
manual.
IMPORTANT
Advise the customer that during the initial burning period of approximately 2 hours, some smoke
and odour may be experienced.
During this period the heater should be operated on 'High' and the space being heated should be
well ventilated. It may take up to 20 minutes of operation for the logs to achieve their full flame
pattern and glow.
THE GUARD IS FITTED TO THIS APPLIANCE TO REDUCE THE RISK OF FIRE OR INJURY
FROM BURNS AND NO PART OF IT SHOULD BE PERMANENTLY REMOVED.
WARNING
FOR PROTECTION OF YOUNG CHILDREN OR THE INFIRM, A SECONDARY GUARD IS
REQUIRED.
The glass dress guard supplied with this appliance MUST NOT be permanently removed as it
fulfils an operational safety function. Additional dress guards including free standing types may
be used in conjunction with, but NOT replace, the dress guard supplied with this appliance.
The appliance is not intended for use by young children or infirm persons without supervision.
Young children and the infirm SHOULD be supervised at all times when in the vicinity of this
heater while it is in operation.
Ensure the Customer understands that:
•
No part of this appliance should be permanently removed.
•
Young children and the infirm should be supervised at all times.
•
Paper or other material MUST NOT be burnt in this appliance.
The following checklist to be completed ONLY by a Certified Gas Installer.
IMPORTANT
Is the appliance positioned in a suitable location (clearances, combustible clearances,
1.
mantels and surrounds etc.)?
2. Was a Rinnai approved flue system installed and tested in accordance with the instructions?
3. Has the gas pressure checked and set?
4. Has the log set / burn media been installed as per instructions?
5. Was the appliance tested for correct operation and to ensure no gas leaks?
6. Has combustion product spillage testing been conducted in accordance with AS/NZS5601?
7. Has the customer been instructed on operating procedure and safety requirements?
8. Is the end-user fully aware of operating procedure?
9. Has the Glass Dress Guard been fitted?
10. Has the customer been advised not to remove the glass dress-guard?
11. Has the customer been advised to service the heater every two years?
Rinnai 30
No Yes
RIBF25 OIM