Table of Contents
Advertisement
9132 Portable IR Calibrator
User's Guide
When the set-point temperature is changed the controller switches the well heater on or off
to raise or lower the temperature. The displayed well temperature gradually changes until it
reaches the set-point temperature. The well may require 5 to 10 minutes to reach the set-point
depending on the span. Another 5 to 10 minutes is required to stabilize within ±0.1°C of the
set-point. Ultimate stability may take 15 to 20 minutes more of stabilization time.
10
info@Fluke-Direct.com
Fluke-Direct
.com
1.888.610.7664
Advertisement
Table of Contents
